A basic approach to removing and replacing a bathroom sink faucet

From time to time, you may need or want to replace your bathroom sink faucet. Since this is such a rare event, it’s easy to be intimidated by the prospect of it.

How does one go about doing this? Where should you start? Rest assured, it’s not that complicated. In fact, it is quite simple. Follow the steps below to replace your bathroom sink faucet.

First, you need to gather all the necessary tools and materials to complete the job. You will need an adjustable wrench or wrench set. You will use them to take apart and put back together your faucet accessories.

Get some cleaning supplies so you can clean any dirt, grime, and mold that may have built up under your old sink faucet. You’ll also need some caulk and teflon tape to seal things up after you install your new faucet.

Last, of course, you’ll need your new faucet. The easiest way to do this is to get a fixture that will fit into the holes in your existing counters. If not, you will have to drill new holes or get a new countertop to fit the new installation.

Before you begin, turn off the water. You can cut off the supply to your bathroom sink, but the safest route to take is to turn off the main line. Next, open the faucet to remove any excess water in the lines.

Now, get under the sink and remove the nuts that connect the water supply lines to the faucet. Next, you will need to remove the retaining nuts that hold the faucet attachment to the counter. They can be quite difficult to get to, so consider getting a lavatory key if you don’t already have one.

Once you have removed the retaining nuts, pull the faucet attachment out from the top. Clean the area with a solution of bleach and powdered laundry detergent. Dry the area completely so mold doesn’t build up under the new faucet. We strongly recommend that you use a hair dryer.

Once the area is dry, attach the new accessory. Screw in the retaining nuts. Go back to the top and wipe off any excess sealant that was pressured out.

Then go back down under the sink and wrap the faucet connections with plumber’s tape. You don’t need much, just enough to wrap around the bottom edge twice. Be sure to wrap it clockwise.

Then reconnect the water supply lines. Make sure everything is tight and secure, and turn the water back on. Let the water run to check for leaks. If there are none, you have successfully replaced the bathroom sink faucet. All that is left is to cover the base of your new faucet with caulk and allow it to dry for 30 minutes. Give yourself a pat on the back.